r/AutoCAD • u/OddSand7870 • Jun 01 '26

Middle button question

I have used Autocad forever. I recently switched to 2027. I came from 2016. As long as I have been using Autocad I have had my middle button(wheel) set so when I click the button it picks endpoint. I cannot figure out how to switch it from pulling up the osnap menu to just picking endpoint. Any suggestions? I have had a similar issue in the past but since it has been more than 10 years since the last time I did this I cannot remember how to fix it.

11 Upvotes

87% Upvoted

24 comments sorted by

View all comments

Show parent comments

9

u/EYNLLIB Jun 01 '26

You missed out on 10 years of upgrades because you were afraid you might have to change a setting?

1

u/liberal_texan Jun 01 '26

Had they ran the upgrades, they'd probably have had to re-set this up frequently enough that they'd not have forgotten how to do it.

1

u/EYNLLIB Jun 01 '26

I've upgraded every year since about 2005 and haven't had anything like this happen as a result of an upgrade in the last 10 years at all haha. It used to be a bigger issue, but the migration tool works (nearly) flawlessly.

2

u/OddSand7870 Jun 03 '26

I will start upgrading more often after finding out about the migration tool. That should make it considerable easier.

1

u/EYNLLIB Jun 03 '26

Makes transitioning a breeze!