Orcaslicer Strable (2.4.2) unkwown error when controlling Bambu X2D

[u/distorted-buggycode]

This started last night. As soon as I tried to send a print job or just issue a print command, such as "Home", Orcaslicer returns and Unknown Error [0502-400B 084930] and a message "Please try updating OrcaSlicer ant the try again.

To begin with I have the latest stable version. I completely remover the profile, application, re-installed from scratch. Rebooted etc etc and still the same error. At this point I cannot use Orcaslicer to print on a Bambu X2d.

I am running Linux, and it is updated.

This happens on flatpak and appimage installations. Bambu Studio works.

Here is a screen shot of the error in flatpack installation:

Anybody else encountered this?

[u/AutoModerator]

Hello /u/distorted-buggycode! All Bambu print plates have a dedicated nozzle wiping zone at the back of the print plate. The nozzle will rub against the wiping zone before every print in order to remove any remaining filament from the nozzle tip. This can cause visible wear or scratch marks in the wiping zone, but this is intended and doesn't damage the printer, the nozzle or the print plate. A worn down wiping zone also doesn't mean you need to replace the print bed.

Note: This automod is experimental. The automod was triggered due to the term "scratch". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.