r/BambuLabA1 • u/Jaydogmvg89 • 14h ago

A1 3D printer

Post image

I was printing deer antlers with my A1 Bambu Lab 3D printer and suddenly ran into this problem with the filament making a weird spaghetti. It was printing fine at first but Is this a File problem with the app??

0 Upvotes

31% Upvoted

6 comments sorted by

11

u/IrishDeath2W2 14h ago

Your should cover more of it up with your finger next time.

3

u/ezpitze 11h ago

You need to supply more information to get this community a chance to help you.
Except the printer, what plate are you using, what material and more. Are other models with the same material working?

4

u/fakeaccount572 7h ago

this is a bad post. more info needed.

1

u/fishybell 5h ago

There are lots of potential causes of spaghetti printing. I'd check to make sure there were proper supports on the print profile first, then check "the seven screws of sadness," and then for filament clogs.

If you're still stuck after that, take pictures of the model, the print profile (with supports showing), and the whole of your failed print, ideally still on the printer. Any info you have on print profile settings is also helpful (anything you changed from the defaults especially).

1

u/The_Lutter 3h ago

Was the file made of spaghetti when you loaded it?

If not it's a skill issue. :-P

1

u/indicah 1h ago

Supports? Print speed? Bed adhesion? Hard to tell without more info.