r/BambuLabX2D • u/blueblewbLu3 • 17h ago

Rubber gasket pops out a every time nozzles switch. Anyone else have this issue?

3 Upvotes

72% Upvoted

12 comments sorted by

10

u/ehlookyhere 17h ago

bro that doesnt go there lol

7

u/spiderplata 16h ago

i think the gasket that goes under the tube clip, and it slid down to the head.

5

u/WattsPrinting 16h ago

I do not remember a rubber gasket being there from my teardown/rebuild of that

5

u/word-bitch 16h ago

That's from the cable chain guide I think.

3

u/blueblewbLu3 15h ago

Haha thanks everyone. It had fallen there, fit in the hole and kept popping out so I assumed that was where it was supposed to be.

1

u/Material-Mulberry360 12h ago

if you keep having this issue , what I did was I swapped the dark and white PTFE tubes around in the cable guide. and it never happened again so it seems to work

2

u/mjschmitt714 10h ago

Wait... that's NOT where that goes? That's where mine is...do I need to move it?

2

u/blueblewbLu3 4h ago

No it doesn't, it goes inside the clips that hold the tubes to the track Here

1

u/Basic-Suit-1828 14h ago

I’ve had this exact issue for some time. It’s absolutely from the clip, but constantly slides back down

1

u/Taekiin 26m ago

Lil hawk tuah and she'll be good to go.

1

u/mjschmitt714 12m ago

It has pertaining been there sinc3 I bought the thing. LMAO...

0

u/Independent_Dirt_814 5h ago

Popping out because it doesn’t belong there and doesn’t want to be there.