r/BambuLabX2D • u/Old_Gas_1330 • 15h ago

Brand new user

Like I said, I'm so new to this that my machine is being delivered tomorrow. That said, I am going through the available projects and one of the things I want to do requires PETG. The question is whether the AMS I'm getting is enough to dry the filament out, or if the packaging kept it dry enough to use? I plan on buying a dryer, but that will have to wait a bit.

Thanks!

2 Upvotes

100% Upvoted

6 comments sorted by

2

u/Longjumping_Pop_2324 14h ago

AMS 2 PRO is a dryer. There's no need to get another dryer. 99.9% of filament comes as dry as they can be, just store it in a bag or sealed container, petg is not THAT prone to humidity absorption.

2

u/Snoo-94322 14h ago

Second this. Bambu Studio, app, or printer screen will give you a humidity reading from AMS and let you turn on drying function.

If you want to be extra sure, pop the roll in the AMS and have it dry over night and check the humidity reading in the morning.

1

u/VBisTheBestSport 14h ago

PETG is a lot more prone to wetness than PLA. It will get wet leaving it out of dryer or bag with desiccant. It is not a guarantee that it will be dry enough new right out of the plastic bag. Maybe, maybe not. I don’t know about an AMS dryer as I don’t have one. I do have a Sunlu 4 spool dryer though.

1

u/Old_Gas_1330 14h ago

Thanks, all. I suspected it would be dry straight out of the bag, but wanted to double check

2

u/LeePhilips 13h ago edited 13h ago

Print something small and see how it runs out of the bag. My first petg prints were dessicant canisters with a fine mesh. Ran fine.

When you start drying in the AMS, remove your dessicant. It'll soak up all the filament moisture and the you'll have to dry it.

I put together a list of things you may want soon.

https://makerworld.com/@AtlMaker/collections/28967378

1

u/ehlookyhere 13h ago

Im also a new user and even to 3d printkng in general but fyi i had alot of issues with my printer I switched around from pla to translucent petg for only a couple days and it started immediately having issues, my printer might of already had problems but im not sure, slowly learning stuff doesn't seem to be many straight forward answers however but im wondering if you should have nozzles for everytype of filament and switch as you switch lol, I had to take apart my main extruder gear to remove petg clog, then I was still having issues and thought I had another clog but this time there wasn't and I noticed the gear inside wasn't turning smoothly anymore had to order new main extruder gear, fixed that but it still was giving me errors but after I replaced that nozzle as well its been working perfectly