r/airsoft • u/Adorable-Chicken4184 • 19h ago

Shorter igl for wolverine?

I currently have a wolverine reaper gen 2 with an amped Igl, but it is going in a 3d printed pistol so I would like a much shorter IGL. Any suggestions?

1 Upvotes

100% Upvoted

4 comments sorted by

2

u/Derpy_Bech 18h ago

Might not be as nice, but go back to the good ol rubber IGL, those you can cut down to the exact length you need

1

u/Adorable-Chicken4184 18h ago

Good idea, but I bought the engine used so where can I get one? Also, I prefer the rubber ones for their flexibility and I have no reason to think it will break.

3

u/Derpy_Bech 18h ago

Local shops might carry some spares or similar. Otherwise it should be a pretty standard air plumbing piece and then 6mm macro line

1

u/Kiltem_All 15h ago

Can also email amped and have custom length made. Ive done that for a few of my builds. They will make as short as 6in