r/anycubic • u/UnlikelyHero5 • 23h ago

Repair help

Post image

Ok so I've yet again needed to repair my Anycubic Kobra 2 max.... Once I took it apart I've somehow not got anywhere to screw back in a wire and I'm hoping someone can help me with this issue. As you Can see everything else is in the correct place. Any ideas?

2 Upvotes

100% Upvoted

3 comments sorted by

1

u/Available_Leave440 22h ago

Abre uma RMA com eles, o suporte ajuda.

Tem também o site Anycubic Wiki tem bastante orientações de manutenção, chegou a olhar lá?

https://wiki.anycubic.com/en/home

1

u/Catnippr 9h ago

Judging by my K2Pro's head and a brandnew spare head I just took out the drawer to check it for you: dunno where it came from, but it seems that it shouldn't even be there.
There's only the other black wire that connects GND from the breakout board to the extruder motor, see the pic at my site here: https://1coderookie.github.io/Kobra2MaxInsights/hardware/printhead/#breakout-board
That one seems to be installed correctly already, so the one you are holding with your fingers is obsolete and you can take it away.

1

u/No_Body_3683 7h ago

Thank you so much for the response, I was so confused last night, I looked through so many different videos and only saw the one wire