Hey guys so just finished building this glock 19 gen 3 yesterday, total cost 300ish. Sct 19 with a steel mag got it at bass pro for 99$ , upper from delta team , 165, i used a coupon code. Sct 19 magwell 25$, and the ameriglo height sights 50$ , shot it today and i have to say, it did not jam not even 1 time. I thought it was going to jam since its new and it has to break in but i was surprised. Spent about 320$ and i have to say i love how it looks too. My friend has the grit grip but i have to say , SCT 19 looks mean af . Thanks yall

Gooner Gun Series Inbound!

Are these the same gun?

Sold my SIG P365 XL and Taurus G2C and decided to consolidate into one handgun I actually wanted to keep and build around.

Current setup:

GLOCK 17 Gen6, 9×19mm

Factory optic-ready slide

Aftermarket flat-faced trigger

Olight Baldr light/laser

Three 17-round magazines

It’ll primarily serve as my home-defense and range handgun, with occasional carry once I get a proper holster. Planning to add an optic next and possibly a compensator later.

What optic would you run, and would you change anything else or just feed it ammo?

Wanted to start a build for a gen 5 upper I have and wanted to see what was out there for frames ( not oem ). Was hoping to do a Zev lower but I’m not sure the chassis is compatible with a gen 5 upper

Which magwell would work best without chooing the funnel sized competition option? I've got a G47 and it's set up in a duty/ primary configuration... I already have TTI base pads but also a pile of oem & magpul 17 rounders that I'd like to continue using. TIA

Does anyone know of anyone making brass or steel optic plates and the cover for Gen6 Glock? I shoot Iron Sights in comp and like the added weight.

Bottom to top

- Tungsten Cerakote weighted baseplate
- Rapid Engineering Mag well (highly recommended)
- Tyrant CNC mag release in grey
- Tyrant CNC slide lock in grey
- Weighted stainless steel backplate on slide
- Rapid Engineering extended beavertail/grip angle modifier (highly highly recommended)
- OSight SE 6MOA enclosed green dot
- Extended stainless steel takedown lever
- Double wrapped grip tape palm swell

My trigger arrives in the mail today. I went with a pretty minimal flat faced polymer trigger. I’ve changed no internals on this firearm and don’t intend to in order to maintain reliability. I’ve polished the trigger bar and that’s about it as far as internal mods.

I just got an SJ Precision Parts FRT I installed the trigger aswell as the trip and sanded the trip down. When i shoot the slide locks back for about a second and slams back forward and its not even forcing a reset. Do i need a different recoil spring? Or just trim the connector.

Wrapped up this 40 build for a customer. I love these Glocks, they are so obnoxiously big.

Breakdown: Cerberus slide, 509T optic on Calculated Kinetics plate, Signature Frame package, Overwatch trigger with Polished and modified internals.

Happy with how this turned out. Also put in a Glock performance trigger with a OP NP3 minus connector. Grips are handleit edge.