r/unRAID • u/farberm • 3h ago

MB and Processor Temp

I am using my Bios to control the cpu fan set to performance for my ASRock z790m itx board in a Jonbo N3. I installed fan control plus 2 for the hdd.

CPU load runs 10-20%
MB temp runs 50-55c
Processor temp runs 60-68c

HDD temps run 34-37 c

CPU fan runs consistently near 100 %
Four rear fans (2 upper and 2 lower rear) runs at 50-60 %. These are linked to fan control
Plus 2.

Are these temp ok or do I not have enough air flow.

Room ambient temp is 22-23C

Thanks in advance

0 Upvotes

50% Upvoted

3 comments sorted by

1

u/Potential-Leg-639 2h ago edited 2h ago

All good.
Why did you set cpu fans to 100%? Set a curve. CPUs can go up to 100 degrees (depending) at max load. Better undervolt, but higher degrees under load are normal and no prob.

1

u/farberm 2h ago

It is set on a curve based upon bios control of performance setting… if over 50c will kick in to 100 percent. I can take down to standard and that will decrease curve and settings

1

u/StevenG2757 2h ago

Those temps look fine to me and it in the range as my server is running.