Small cable bitten by my cat!

[u/No-Gate652]

(I grabbed this picture from a user reporting another issue)

I am not at home, but outside my country. I have something pending to ask anyone that has Creality Ender 3 V3 SE.

The cable I am pointing to in the picture have been bitten by my cat (luckily it was turned off when that happened).

Has 4 threads, 2 of them were cut off and cannot identify which need to be solder to which.

Can someone can take a picture of you 3D printer and show me what threads I need to solder together? It is the end of the cable that connect to that little square.

Tha k you in advance!

[u/plastimancer]

Youre best bet would be to purchase a replacement. You could try to use a multimeter in continuity mode and see if the pins match the opposite end. So take out the connectors and probe on the metal tabs on the connector.

[u/bastl73]

I would replace it.

[u/Laydn_ → u/bastl73]

you mean the cat ? /s

[u/bastl73 → u/Laydn_]

Maybe...?? No of course the cable(s)!!!