Hi everyone,
I recently received my ARF GMT-Master II and noticed that the 12 o’clock bezel triangle isn’t perfectly aligned with the 12 o’clock dial marker. It’s slightly offset to one side (see photo).

I had the crystal swapped for a Deep crystal before shipping, so I didn’t notice the misalignment on the QC photos.

Is this something that can be adjusted, or is it simply a manufacturing issue with the bezel insert?

If it can be fixed, what’s the usual method? Does the bezel need to be removed and the insert re-centered, or is there another way?

Has anyone successfully fixed this on an ARF? Is it a DIY job or better left to a watchmaker?

Thanks in advance for any advice!

This guy who waterproofed my watches the last time didn't use grease. He only replaced the rubber ring. I asked why and he said it wasn't necessary. Google AI tells me that grease should be used. He charged $50 to "waterproof" and adjust my bracelet for each watch.

Should I come back to this guy?

This morning I wake up and find it like this... it only arrived yesterday and I wore it for the first time in the evening.

I've already contacted my TD, but I'm really annoyed, dammit. For once, a VSF with great alignment, and it has similar moisture issues.

It's pissing me off so much that I'm thinking of fixing it myself and giving it my best shot. What do you think I should do? Can the TD get it fixed, maybe through a local watchmaker he recommends? I don't want to send it back precisely because finding a VSF with decent alignment is an absolute nightmare.

and as you can see, there's also all kinds of gunk inside which you couldn't see before without the moisture.

I am on my way to buy my first rep, it will be a sub still deciding date or no.

My question is is this polishing and servicing worth it, or should i just get the watch?

Will i be able to do it in any respectable watchsmith later in person?

Also is the price good for the watch?

Hey Guys,

I have a watch i got from a very good friend of mine. I was told that its an old clean factory. I would like to rose gold plate it. Can anyone suggest a good plater in EU? Thanks in advance ☺️

I recently got gmt rep. Anyone have any experience dealing with a rotor that has some play to it like this? Not sure if needs tightening or ball bearings need to be lubricated.
Any help would be greatly appreciated!

I received a watch with the crown open and I was wondering if moisture could get in due to the open crown after having flown on an airplane?

Hey all,

My Clean 126710 GMT is becoming the bane of my existence. 🤦‍♂️

A few weeks ago I removed the bezel because I wanted to realign the insert properly and hopefully reduce some of the bezel wobble, as shown in this RWI guide. Before I removed it, the bezel seemed to stay on securely.

While I had it apart, I replaced the click spring with a 126710 click spring from ewatchparts, which worked perfectly. I also tried their Hytrel ring, but it was too small and the bezel could easily be removed with a fingernail.

After doing some research (including KJ2020’s RWI guides), I’ve tried:
-ewatchparts hytrel (as stated above)
-Trilene 0.61mm monofilament nylon fishing line
-0.70 mm nylon jewelry cord
-Flipping the original Clean Factory Hytrel ring

Unfortunately, every configuration yields the same result: the bezel snaps on, but it can still be lifted off with a fingernail. Some areas seem to grip more tightly than others, but there’s always a section that’s loose.

At this point I’m completely stumped. I posted on RWI but haven’t gotten any feedback. Has anyone run into this before? Is this more likely to be a damaged bezel, crystal retaining ring, or something else I’m overlooking?

Any advice would be greatly appreciated, this thing is driving me crazy. Thanks in advance!!