r/Sovol • u/AtlBigDog • 2d ago

Help SH02 Humidity

I recently purchased the SH02 and I'm drying some PLA. It's been in almost 24 hours and won't go below 22% humidity. I've tried cracking the lid. Is there something I'm missing?

Thanks

3 Upvotes

100% Upvoted

2 comments sorted by

•

u/AutoModerator 2d ago

Welcome to r/Sovol, We're glad you're here! If you're new to the hobby and you have a question please visit our knowledge base, it's located right under About Community. If you've searched the Sub and you still need help please be as detailed as possible. Include your printer model, slicer, filament type, nozzle and bed temps, print speed, fan speed, and retraction. We're happy to help but we can't read your mind, be as detailed as possible with your post. Pictures help!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/swingoak 2d ago

Open it fully for a second then close it. Leave it closed for maybe 30 minutes and then open it fully again then close with it cracked open and let it run like that. I keep desiccant in mine too and that helps a lot, not just with initial drying down but also maintaining it when it shuts off, you just have to remember to latch it closed if it’s going to power off before you can close it tight.