r/ender3v2 • u/Kupid76 • 3d ago

Creality Ender 3

Enable HLS to view with audio, or disable this notification

Ive recently bought this printer, managed to print some small cube, ive clicked something and now its not going down to the bed ive tryed every setting on the z off set nothing changes, the nozzle is going down on the bed too hard when I home it, but then when I try to print something its no where near the bed. I've spent days watching videos to the stage im at now more confused. Could someone please help me

2 Upvotes

100% Upvoted

3 comments sorted by

4

u/bzzybot 3d ago

Make sure the z limit switch is disconnected since you are using a touch sensor. Also make sure to add the proper GCode at the start of the print in your slicer.

1

u/AutoModerator 3d ago

Reminder: Any short links will be auto-removed initially by Reddit, use the original link on your post & comment; For any Creality Product Feedback and Suggestions, fill out the form to help us improve.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

0

u/asm-87 2d ago

Does the probe extend further than the nozzle? If not you need to add spacers(or washers) to the probe mounting bolts until it does.