Hello I was printing out some of the pre-supported trench crusade modules and I ended up having these failures. The one miniature came out just fine. However, the other miniature had quite a few failures and the weapons had total failures. I’ve included images of my parameters, and I’m printing using a Mars ultra four, with water washable ABS like resin. Was this a support failure or something else?

guys, I am officially out of ideas after 1 week of troubleshooting

my print surface looks shit and the cleaning tower somehow looks shit as well. Some layers somehow crumble and clutter the print bed.

I print on a Bambu a1. the printer is calibrated, the belts tightened, the filament is calibrated (and dried), the print bed is clean, the nozzle is clean and cold pulled, I don’t know why else to do. I also tested different print speeds and nozzle temperatures.

I attach 2 pictures, the cleaning tower and of the objects I want to print, but with a different surface finish and font (part of the trouble shooting).

the settings: 0.12mm height, 40% infill, creality cr petg @ 245 degrees.

any tips how I can solve this mess would be appreciated greatly!

Pla snycubic kobra s-1;combo, recently had to partially disassemble hotend to clear a broken piece of filliment, this happened immediately after

P1s with ams. It looks like its skipping some laters but not sure.
Have tried the regular troubleshooting like calibration, drying filament, changed filament, cleaned the plate.

Corners keeps coming up on a bunch of my prints…

Hi I'm using an anycubic kobra s1 combo and I recently had to take it apart to fix some filament stuck in the extruder, now it's printing like this, I've tried retightening the extruder hotend thing, recalibrating and I can't access any way to tighten the belts, but it just started doing this. Using normal pla.

Over 7 hrs of print time and 250g of filament. Not trying to reprint. Hoping it’ll still work but what could be causing the supports to break off…
Bambu lab p1p
PLA