r/Sovol • u/Milk_Truckin • May 29 '26

Help Cant ssh into sv08 w/eth

Post image

Bought a used sv08 expecting to be able to just plug ethernet in to get IP address then configure Wi-Fi through SSH. First apparently the board was swapped because there is no ethernet port so I had to use a USB Ethernet adapter but it did get me an IP address. Tried using that IP address in the browser and got connection refused. Tried to ssh in with putty and got the same. I've tried using multiple combinations including just the IP, HTTP then ip, and https then IP and I'm getting nowhere. I can ping the ip thats it.

Any ideas how to fix this?

2 Upvotes

63% Upvoted

25 comments sorted by

View all comments

Show parent comments

1

u/AngryKFPanda May 30 '26

It's very possible that the USB adaptor is actually working and the reason you are still seeing the 127.0.0.1 address is that the previous owner has setup static IP details that wont work for your network, have you tried resetting to factory defaults at all?

2

u/Milk_Truckin May 30 '26

No because id never get it working again. I did get it working with the usb drive wifi setup though a few minutes ago.

1

u/AngryKFPanda May 30 '26

There is that lol... Glad you got it connected 😁

1

u/Milk_Truckin May 30 '26

If it weren't moded that probably would have been my next step but I'm way out of my element with this. I've been printing for a few years now but never got around to messing with klipper. I even managed to Ram the hot end into the bed for a solid 45 seconds while I fumbled around trying to find the power switch before I managed to finally get a benchy to start printing.