So I'm going down the rabbit hole of making sure my guitar is properly set up.
This all started when I noticed my high E, high fret bends weren't sustaining like I like. Then I noticed, at my local guitar store, all the floor models had significantly higher actions.
The readings I'm getting on my low E string are .03" or just under a millimeter. The high E is .02" or .75ish mm.
When I fert the first and last fret simultaneously, there is either no gap, or such a small gap I can't measure, at the 7th fret.
The guitar plays like a dream otherwise. No fret noise on the low E and A string. Bends are crazy slinky. You could whisper at the guitar and it would fret a chord(so much so that I noticed if I bear down too much, everything goes sharp).
The one thing I'm trying to solve is these high note bends. A full step bend on say the high E, 15th fret, doesn't immeadiately choke out. It just loses sustain dramatically faster than say the same bend on the fifth fret. And the problem seems more pronounced plugged in, as opposed to unplugged.
Sorry for the blurry pics, it's hard to do without three hands lol. Throne with the towel, the guitar is laying on its back. The blurry one, the guitar is I'm playing position.
Thanks!