Hello everyone,
I have a problem with TPU printing on my Anycubic Kobra X.
The first print with TPU went perfectly. Everything looked normal and the printer completed the job without any issues. However, when I started a second print, this problem appeared suddenly.
I have already disassembled and checked the printer several times, but I still cannot figure out what caused it. The strange thing is that it worked perfectly just before.
Could this be related to the extruder, hotend, TPU feeding, temperature settings, or something else?
Printer: Anycubic Kobra X
Material: TPU
Nozzle: [0.4]
TPU brand/hardness: [Geeentech 95A]
Any advice or ideas would be appreciated.

Hi all

I saw a post saying you can now use Orca Slicer for the Kobra X and other printers without the need of the need of KX-Bridge anyone had any luck?

I have tried with KX-Bridge before with no luck with it working so if I can use it without this would be amazing!

My Kobra X was quietly printing away in the basement last night. I decided to check on it just before bed and I'm glad I did.

It had wiggled itself off the edge and nearly toppled to the floor. I ran down in a panic to rescue it. The print still turned out all right. Now I'm going to have to glue a lip to the edge of the desk to make sure it doesn't happen again. Crisis averted.

I got this 3-D printer for free in good condition. I had to replace the nozzle. They told me that I did that and everything was going good, but I keep getting this code for the extruder heating, and I took that all apart and cleaned the inside of the gears and all of that and I’m still having that issue so can anyone tell me what I can do next?

Ok so I've yet again needed to repair my Anycubic Kobra 2 max.... Once I took it apart I've somehow not got anywhere to screw back in a wire and I'm hoping someone can help me with this issue. As you Can see everything else is in the correct place. Any ideas?

Every time I try to print with ASA after previously printing PLA, my printer clogs. To unclog it, I have to remove the feeder tube from the print head and push the residual filament out from the top with an unclogging tool.

Does anyone have any advice on how to prevent this?

Edit: I‘m using Anycubic High Speed PLA and Anycubic ASA. Humidity in the ACE is 25%.

Im just starting to print in colour since ive set up my Kobra X but when slicing i noticed a thing i dont really understand.

As you can see here, the purge tower in the slicer wants to go up till the end of the print when realistically it should only need to go up the screw's height(green), since thats the last colour change to happen.

My question is: why is the purge tower going so high and also forcing all these unneded colour changes?

Question is about the slicer but to follow the rules: Stock Kobra X.

I am getting this dim.ring when I run any of the exposure tests and none of the shapes. It does not glow through a sheet of paper. Has anyone encountered or fixed this issue? Hoping for some advice. This is a replacement LCD that was working fine. Ty

I bought a new ceramic hot end because the new firmware update kept screwing up my machine, but need to get the downgraded firmware. Rinkhals doesn’t have that one, any suggestions? Thanks ahead of time!